CLI Guide

protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id Enter zero (0). Dell Networking OS supports one spanning
tree group, group 0.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally
on the switch, use the no disable command from SPANNING TREE mode.
Example
Dell(conf)# protocol spanning-tree 0
Dell(config-stp)#
Related
Commands
• disable — disables spanning tree group 0. To enable spanning tree group 0, use
the no disable command.
1742
Spanning Tree Protocol (STP)