CLI Guide

Version Description
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
You can configure up to eight allow-remote entries on any multipoint receive-only
tunnel.
This command fails if the address family entered does not match the outer header
address family of the tunnel mode, tunnel source, or any other tunnel allow-
remote.
If you configure any allow-remote , the tunnel source or tunnel mode commands
fail if the outer header address family does not match that of the configured allow-
remote.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Tunneling
1773