CLI Guide

You can assign an interface to only one uplink-state group. Configure each

interface assigned to an uplink-state group as either an upstream or downstream

interface, but not both.

You can assign individual member ports of a port channel to the group. An uplink-

state group can contain either the member ports of a port channel or the port

channel itself, but not both.

Example

Dell(conf-uplink-state-group-16)# upstream gigabitethernet

1/10-15

Dell(conf-uplink-state-group-16)#

Commands

• downstream — assigns a port or port-channel to the uplink-state group as a

downstream interface.

• uplink-state-group — creates an uplink-state group and enables the tracking of

upstream links.

Uplink Failure Detection (UFD)

1793