CLI Guide

member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel, and then a number.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet , and then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet, and then the slot/port
information.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable the stackable VLAN (using the vlan-stack compatible command) on
the VLAN prior to adding a member to the VLAN.
Related
Commands
• vlan-stack compatible — enables stackable VLAN on a VLAN.
VLAN Stacking
1797