CLI Guide

To remove the trunk port designation, first remove the port (using the no member
interface command) from all stackable VLAN-enabled VLANs.
In Example 1, a VLAN-Stack trunk port is configured and then made part of a
single-tagged VLAN.
In Example 2, the tag protocol identifier (TPID) is set to 8848. The Gi 3/10 port is
configured to act as a VLAN-Stack access port; the TenGi 8/0 port acts as a VLAN-
Stack trunk port, switching stackable VLAN traffic for VLAN 10, while also switching
untagged traffic for VLAN 30 and tagged traffic for VLAN 40. (To allow VLAN 30
traffic, you need the native VLAN feature. Use the portmode hybrid command.
For more information, see the
portmode hybrid command.
Example 1
Dell(conf-if-gi-1/42)# switchport
Dell(conf-if-gi-1/42)# vlan-stack trunk
Dell(conf-if-gi-1/42)# show config
!
interface GigabitEthernet 1/42
no ip address
switchport
vlan-stack trunk
no shutdown
Dell(conf-if-gi-1/42)# interface vlan 100
Dell(conf-if-vl-100)# vlan-stack compatible
Dell(conf-if-vl-100-stack)# member gigabitethernet 1/42
Dell(conf-if-vl-100-stack)# show config
!
interface Vlan 100
no ip address
vlan-stack compatible
member GigabitEthernet 1/42
shutdown
Dell(conf-if-vl-100-stack)# interface vlan 20
Dell(conf-if-vl-20)# tagged gigabitethernet 1/42
Dell(conf-if-vl-20)# show config
!
interface Vlan 20
no ip address
tagged GigabitEthernet 1/42
shutdown
Dell(conf-if-vl-20)# do show vlan
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
* 1 Inactive
20 Active T Gi 1/42
100 Active M Gi 1/42
Dell(conf-if-vl-20)#
Example 2
Dell(config)# vlan-stack protocol-type 88A8
Dell(config)# interface gigabitethernet 3/10
Dell(conf-if-gi-3/10)# no shutdown
Dell(conf-if-gi-3/10)# switchport
Dell(conf-if-gi-3/10)# vlan-stack access
Dell(conf-if-gi-3/10)# exit
1804
VLAN Stacking