CLI Guide

Version Description
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information
When you use this command, the management ports corresponding to both the
active unit and the standby unit are associated with the management VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax
maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit Maximum number of routes allowed in a VRF. The valid
range is from 1 to 16,000 (or maximum allowable for that
platform if a smaller value).
warning-
threshold
The warning threshold value is a percentage of the limit
value. When the number of routes reaches the specified
percentage of the limit, a warning message appears. The
valid range is from 1 to 100.
After the limit is reached, additional dynamic routes are not
allowed.
warning-only When you use the warning-only option, when the
maximum number of dynamic routes reaches the limit, a
warning message appears.
After the limit is reached, additional dynamic routes are still
allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes CONFIGURATION-VRF
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
1816
Virtual Routing and Forwarding (VRF)