CLI Guide

Parameters
interval Enter the interval value (in seconds) for the delay restore
timer to abort. The range is from 1 to 1800 seconds. The
default is 60 seconds.
This delay restore timer applies only during reload/boot-up
and not in other scenarios (for example, during ICL flap).
Defaults 60 seconds
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4820T, S4810, S6000, S5000, Z9000,
S6000–ON and Z9500.
Usage Information To abort the VLT delay restore timer value as the maximum threshold, during
reload, apply the maximum time interval to the hold-down ICL peer-up in the
start-up configurations.
lacp ungroup member-independent
Prevent possible loop during the VLT peer switch bootup or on a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
vlt Force all VLT LACP members to become switchports.
port-channel Force all LACP port-channel members to become
switchports.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Virtual Link Trunking (VLT)
1831