CLI Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies to all the VRRP interfaces on a system. When you use this
command with the vrrp delay minimum command, the later timer rules VRRP
enabling. For example, if vrrp delay reload is 600 and vrrp delay minimum
is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
For the delay timers to take effect, save the configuration and reload the system.
Related Command
• vrrp delay minimum — sets the delay time for VRRP initialization after a line card
reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Virtual Router Redundancy Protocol (VRRP)
1869