CLI Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure
a virtual IP address. When you delete the virtual IP address, the VRRP group stops
sending VRRP packets.
Related Command
• virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by
RFC 3768, Virtual Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by
RFC 5798, Virtual Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP
version 2 to VRRP version 3.
Defaults 2
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information You can use the both command to migrate from VRRPv2 to VRRPv3. When you set
the VRRP protocol version to both, the switch sends only VRRPv3 advertisements
1870
Virtual Router Redundancy Protocol (VRRP)