CLI Guide

vrf vrf-name (OPTIONAL) Enter the name of a VRF instance to clear the
counters of all IPv6 VRRP groups in the specified VRF. The
maximum is 32 characters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to clear the interface configurations
corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series, C-Series, and S-Series. Support was
added for IPv6 VRRP groups in nondefault VRF instances.
8.3.2.0 Introduced on the E-Series.
debug vrrp ipv6
Enable VRRP debugging.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet, and then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet, and then the slot/port
information.
• For a Port Channel interface, enter the keywords port-
channel, and then a number.
• For a VLAN interface, enter the keyword vlan, and then
the VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
1872
Virtual Router Redundancy Protocol (VRRP)