CLI Guide

Version Description
6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For
more information, see the Quality of Service section in the Dell Networking OS
Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
The monitor option is relevant in the context of flow-based monitoring only. For
more information, see Port Monitoring.
The C-Series and S-Series cannot count both packets and bytes, when you enter
the count byte options, only bytes are incremented.
NOTE: When you configure ACL logging and byte counters simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
• deny tcp — assign a filter to deny TCP packets.
• deny udp — assign a filter to deny UDP packets.
• ip access-list extended — create an extended ACL.
deny icmp
To drop all or specific internet control message protocol (ICMP) messages, configure a filter.
Syntax
deny icmp {source mask | any | host ip-address} {destination
mask | any | host ip-address} [dscp] [count [byte] [order]
[fragments] [no-drop]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny icmp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
242
Access Control Lists (ACL)