CLI Guide

To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny {source mask | any | host ip-address}
{
destination mask | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the
network from which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may
be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address or hostname.
destination Enter the IP address of the network or host to which the
packets are sent.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes
processed by the filter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
fragments Enter the keyword fragments to use ACLs to control
packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded
packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
252
Access Control Lists (ACL)