CLI Guide

Usage Information
Routers supporting 4-byte ASNs advertise that function in the OPEN message. The
behavior of a 4-byte router is slightly different depending on whether it is speaking
to a 2-byte router or a 4-byte router.
When creating Confederations, all the routers in the Confederation must be 4 byte
or 2 byte identified routers. You cannot mix them.
Where the 2-byte format is from 1 to 65535, the 4-byte format is from 1 to
4294967295. Both formats are accepted and the advertisements reflect the
entered format.
For more information about using the 2 byte or 4-byte format, refer to the Dell
Networking OS Configuration Guide.
This command automatically restarts the BGP instance for the configuration to
take effect.
bgp graceful-restart
To support graceful restart as a receiver only, enable graceful restart on a BGP neighbor, a BGP node, or
designate a local router.
Syntax
bgp graceful-restart [restart-time seconds] [stale-path-time
seconds] [role receiver-only]
To return to the default, use the no bgp graceful-restart command.
Parameters
restart-time
seconds
Enter the keyword restart-time then the maximum
number of seconds to restart and bring-up all the peers. The
range is from 1 to 3600 seconds. The default is 120
seconds.
stale-path-time
seconds
Enter the keyword stale-path-time then the maximum
number of seconds to wait before restarting a peer’s stale
paths. The default is 360 seconds.
role receiver-only Enter the keyword role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults as above
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
428
Border Gateway Protocol