CLI Guide

8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To view information on both incoming and outgoing routes, do not include the in
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter the
debug ip bgp in command and
then enter the debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
Related
Commands
• debug ip bgp events — view information about BGP events.
• debug ip bgp keepalives — view information about BGP keepalives.
• debug ip bgp notifications — view information about BGP notifications.
• debug ip bgp updates — view information about BGP updates.
• show debugging — view enabled debugging operations.
debug ip bgp dampening
View information on routes being dampened.
Syntax
debug ip bgp [vrf vrf-name] [ipv4 {unicast | multicast} | ipv6
unicast] dampening
To disable debugging, use the no debug ip bgp dampening command.
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view information on dampened routes corresponding to
that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view dampened-route information
related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view dampened-route information
related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view dampened-route information
related only to ipv6 unicast routes.
442
Border Gateway Protocol