CLI Guide

Version Description
7.4.1.0 Introduced
Usage Information When you enable failover, BGP keeps track of IP or IPv6 ability to reach the peer
remote address and the peer local address. Whenever either address becomes
unreachable (for example, no active route exists in the routing table for the peer IP
or IPv6 destination/local address), BGP brings down the session with the peer.
Related
Commands
• show ip bgp neighbors — display information on the BGP neighbors.
neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure
Internal BGP (IBGP) routers.
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-
prepend]
To return to the default value, use the no neighbor {ip-address | peer-
group-name} local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that
AS. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted
format).
no prepend Specifies that local AS values do not prepend to
announcements from the neighbor.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
462
Border Gateway Protocol