CLI Guide

NOTE: When you set this option, the router accepts
BGP prefixes only until the maximum configured value.
After the maximum number is reached, the router drops
any additional prefixes that it receives.
Defaults threshold = 75
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than the neighbor maximum-prefix command
configuration allows, the neighbor goes down and the
show ip bgp summary
command displays (prfxd) in the State/PfxRcd column for that neighbor. The
neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related
Commands
• show ip bgp summary — display the current BGP configuration.
neighbor password
Enable message digest 5 (MD5) authentication on the TCP connection between two neighbors.
Syntax
neighbor {ip-address | peer-group-name} password [encryption-
type] password
464
Border Gateway Protocol