CLI Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view cluster information of BGP neighbors
corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keywords ipv4 followed by the
keyword multicast to view information related only to
ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view information related only to ipv4
multicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related to only to the
ipv6 unicast routes.
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format.
The range is 1 — 4294967295.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp cluster-list command shown in
the following example.
496
Border Gateway Protocol