CLI Guide

Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the
VRF to configure the name server to IP address mapping for
that VRF.
name Enter the name od the host to be associated with an IP
address.
ip-address Enter the IP address of the name server in dotted decimal
format.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information Use this command to create a mapping between a host name server and its IP
addresses for a specific VRF.
Example
Dell(conf)# ip host vrf jay dell 1.1.1.1
clear host
Removes one or all dynamically learned host table entries for a specific VRF.
Syntax
clear host [vrf vrf-name] {* | host-name}
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the
VRF to delete dynamically learned host table entries
corresponding to that VRF.
host-name Enter the name of the host corresponding to which you
want to delete the dynamically learnt host table entries.
* Enter * to delete all host table entries.
Defaults None
Dynamic Host Configuration Protocol (DHCP)
637