CLI Guide

ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when
maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-paths Specify the maximum number of ECMP for a route. The
range is 2 to 64.
path-fallback Use the keywords path-fallback to enable this feature. If
you enable the feature, re-enter this keyword to disable the
feature.
Defaults 16
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information You must save the new ECMP settings to the startup-config (write-mem) then
reload the system for the new settings to take effect.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax
ip ecmp weighted
Equal Cost Multi-Path (ECMP)
643