CLI Guide

To disable weighted ECMP calculations, enter the no ip ecmp weighted
command.
Defaults N/A
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prefix paths
with weights in the HW/CAM on the fly.
If disabled, the CLI would inform the FIB to re-program the destination prefix paths
with no weights or regular ECMP.
Example
Dell(conf)# ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)# ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)# no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)# no ip ecmp weighted
Dell(conf)# do show running-config | grep ecmp
link-bundle-monitor enable
Provides a mechanism to enable monitoring of traffic distribution on an ECMP link bundle.
Syntax
link-bundle-monitor enable
To exit from ECMP group mode, use the exit command.
Command Modes
• ECMP-GROUP
• PORT-CHANNEL INTERFACE
644
Equal Cost Multi-Path (ECMP)