CLI Guide

• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
secondary
interface
Enter the keyword secondary to configure the secondary
interface then one of the following interfaces and slot/port
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number.
control-vlan vlan-
id
Enter the keyword control-vlan then the VLAN ID. The
range is from 1 to 4094.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information This command causes the Ring Manager to take ownership of the two ports after
IFM validates the configuration. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not
belong to any ring.
Related
Commands
• show frrp — display the Resilient Ring Protocol configuration information.
660
Force10 Resilient Ring Protocol (FRRP)