CLI Guide

member-vlan
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10. Combination: 3, 4, 5-10, 8.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
mode
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
Force10 Resilient Ring Protocol (FRRP)
661