CLI Guide

Version Description
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
• gvrp enable — enable GVRP on physical interfaces and LAGs.
• protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
GARP VLAN Registration (GVRP)
671