CLI Guide

A: | B: Specify the flash partition of the operating-system image to be upgraded.

Defaults none

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, see the relevant

Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added support for NFS mount.

9.2(1.0) Introduced on the Z9500.

9.0(0.0) Added support for IPv6 for the file-url parameter.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Added support for TFTP and SCP.

7.6.1.0 Introduced on the S-Series.

Usage Information

RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be

enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this command accepts IPv6 host

addresses with or without the square brackets.

After you upgrade the system image, by entering the command. specify the location where the

Dell Networking OS image used to boot the system is stored (boot system), save the

configuration to the start-up config file (

write memory), and reload the system (reload).

Example

Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:

00:39:32 : Discarded 1 pkts. Expected block num : 51. Received block num:

!00:39:36 : Discarded 1 pkts. Expected block num : 65. Received block num:

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.......

...........!!!!!!!!!!!!!!!!!!!!!!!

93924044 bytes successfully copied

System image upgrade completed successfully.

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Image upgraded to all

Dell#

File Management