CLI Guide

Example (Single
Range)
This example shows how to define an interface range macro named test. Execute
the show running-config command to display the macro definition.
Dell(config)# define interface-range test gigabitethernet 1/1
- 1/3,
gigabitethernet 5/1 - 5/22, gigabitethernet 3/1 - 3/8
Dell# show running-config | grep define
define interface-range test gigabitethernet 1/1 - 1/3,
gigabitethernet 5/1 - 5/22,
gigabitethernet 3/1 - 3/8
Dell(config)# interface range macro test
Dell(config-if-range-gi-1/1-1/3,te-5/1-5/22,te-3/1-3/8)#
Related
Commands
• interface range – configure a range of command (bulk configuration).
• interface range macro name – run an interface range macro.
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
744
Interfaces