CLI Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to configure them, see
Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP
ACLs are supported. For more information, see Access Control Lists (ACL).
The following features are not supported on VLANs associated with an OpenFlow
instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot
be enabled simultaneously.
Example (Single
Range)
Dell(conf)# int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
• interface — configure a physical interface.
• interface loopback — configure a loopback interface.
• interface null — configure a null interface.
• interface port-channel — configure a port channel group.
• show vlan — display the current VLAN configuration on the switch.
• shutdown — disable/enable the VLAN.
• tagged — add a Layer 2 interface to a VLAN as a tagged interface.
• untagged — add a Layer 2 interface to a VLAN as an untagged interface.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive
To stop sending keepalive packets, use the no keepalive command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
746
Interfaces