CLI Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Example
Dell(conf-if-range-gi-2/2,fo-2/56)# show range
2/2 - 0
2/56 - 0
Dell(conf-if-range-gi-2/2,fo-2/56)#
Related
Commands
• interface — configure a physical interface on the switch.
• show ip interface — display Layer 3 information about the interfaces.
• show interfaces — display information on a specific physical interface or virtual
interface.
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the
ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40
interfaces (not just LAG link-bundles).
Syntax
show running-config ecmp-group
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces
783