CLI Guide

negotiation either enabled or disabled. For speed settings of 1000 or auto, the
software sets the link to auto-negotiation and you cannot change that setting.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 or 100 Mbps, you can also use the duplex command.
NOTE: In S3100 series, the speed command is not available on the combo
ports.
Related
Commands
• duplex (10/100 Interfaces) — configure duplex mode on physical interfaces with
the speed set to 10/100.
• negotiation auto — enable or disables auto-negotiation on an interface.
speed (Management interface)
Set the speed for the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10
Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100
Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Interfaces
787