CLI Guide

To delete a Port Channel, use the no interface port-channel channel-
number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on S4810.
8.3.11.1 Introduced on Z9000.
8.1.1.0 Introduced on E-Series.
7.6.1.0 Introduced on S-Series.
7.5.1.0 Introduced on C-Series.
pre-Version
6.2.1.0
Introduced on E-Series.
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by
using the switchport command) or Layer 3 mode (by configuring an IP address).
You can add a Port Channel in Layer 2 mode to a VLAN.
The shutdown, description, and name commands are the only commands that
you can configure on an interface while it is a member of a Port Channel. To add a
physical interface to a Port Channel, the interface can only have the shutdown,
description, and name commands configured. The Port Channel’s configuration
is applied to the interfaces within the Port Channel.
A Port Channel can contain any physical interface. Based on the first interface
configured in the Port Channel and enabled, Dell Networking OS determines the
common speed. For more information, refer to channel-member.
Interfaces
799