CLI Guide

Field Description
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in
hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which
interface is the primary port of the port channel. The
primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not
indicated.
Example
Dell# show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/1 (Up) *
Gi 3/2 (Down)
Gi 3/3 (Up)
Dell#
Related
Commands
• show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address}
| {source-port number destination-port number} | {source-mac
address destination-mac address {vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
incoming-
interface interface
Enter the keywords incoming-interface then the
interface type and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
source-ip address Enter the keywords source-ip then the IP source address
in IP address format.
806
Interfaces