CLI Guide

To delete a transform set, use the no crypto ipsec transform-set name
{ah-authentication {md5|sha1|null} | esp-authentication {md5|
sha1|null} | esp-encryption {3des|cbc|des|null}} command.
Parameters
name Enter the name for the transform set.
ah-authentication Enter the keywords ah-authentication then the
transform type of operation to apply to traffic. The
transform type represents the encryption or authentication
applied to traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
esp-
authentication
Enter the keywords esp-authentication then the
transform type of operation to apply to traffic. The
transform type represents the encryption or authentication
applied to traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
esp-encryption Enter the keywords esp-encryption then the transform
type of operation to apply to traffic. The transform type
represents the encryption or authentication applied to
traffic.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
816
Internet Protocol Security (IPSec)