CLI Guide

24
IPv4 Routing
The basic IPv4 commands are supported by Dell Networking OS on the platform.
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
Syntax
arp [vrf vrf-name] ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf vrf-name Enter a VRF name to configure an ARP entry for that VRF.
Use the VRF option after the keyword arp to configure a
static arp on that particular VRF.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-
channel
then a number.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
824
IPv4 Routing