CLI Guide

ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
To fully enable DNS, also specify one or more domain name servers with the ip
name-server command.
Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
• ip name-server — specify a DNS server.
• show hosts — view the current bindings.
846
IPv4 Routing