CLI Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version 9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of protocol routes that the
Route Table Manager can hold for a specific VRF. This command does not apply to
the management VRFs.
Related
Commands
• show ip route — view the switch routing table.
• show ipv6 route — display the IPv6 routes.
ip mtu
Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must
be fragmented, Dell Networking OS sets the size of the fragmented packets to the size specified in this
command.
Syntax
ip mtu value
To return to the default IP MTU value, use the no ip mtu command.
Parameters
value Enter the maximum MTU size if the IP packet is fragmented.
The range is from 576 to 9234. The default is 1500 bytes.
Defaults 1500 bytes
Command Modes INTERFACE (Gigabit Ethernet and 10-Gigabit Ethernet interfaces)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Verison Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
856
IPv4 Routing