CLI Guide

Column
Heading
Description
configured in the Dell Networking OS, this line does not
appear.
Example
Dell> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related
Commands
• show ip route — display information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from
all processors. If you do not enter a keyword, you also view
all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics
from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the
statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the
statistics from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
896
IPv4 Routing