CLI Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced.
Usage Information This command allows you to create an EUI64 address based on the specified prefix
and MAC address only. Prefixes may be configured on the interface using the ipv6
nd prefix command without creating an EUI64 address.
Example
Dell(conf)# int gig 1/4
Dell(conf-if-gi-1/4)# ipv6 address 200:1::/64 eui64
Dell(conf)# int gig 1/6
Dell(conf-if-gi-1/6)# ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the
rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
920
IPv6 Basics