CLI Guide

no-rtr-address Enter the keyword no-rtr-address to exclude the full
router address from router advertisements (the R bit is not
set).
off-link Enter the keywords off-link to advertise the prefix
without stating to recipients that the prefix is either on-link
or off-link.
valid-lifetime |
infinite
Enter the amount of time that the prefix is advertised, or
enter infinite for an unlimited amount of time. The range
is from 0 to 4294967295. The default is 2592000. The
maximum value means that the preferred lifetime does not
expire for the valid-life time parameter.
preferred-lifetime
| infinite
Enter the amount of time that the prefix is preferred, or
enter infinite for an unlimited amount of time. The range
is from 0 to 4294967295. The default is 604800. The
maximum value means that the preferred lifetime and does
not expire.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series, C-Series, and S-Series.
Usage Information By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied
using the ipv6 nd prefix default no-autoconfig command.
926
IPv6 Basics