CLI Guide

NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
distance (OPTIONAL) Enter a number as the metric distance assigned
to the route. The range is from 1 to 255.
tag value (OPTIONAL) Enter the keyword tag then a tag value
number. The range is from 1 to 4294967295.
permanent (OPTIONAL) Enter the keyword permanent to specify that
the route is not to be removed, even if the interface
assigned to that route goes down.
NOTE: If you disable the interface with an IPv6 address
associated with the keyword permanent, the route
disappears from the routing table.
weight weight-
value
Enter the keyword weight followed by a weight value. The
range is from 0 to 255.
NOTE: Weight for a static route can be added only for
the destination address and not for the route pointing to
destination a interface.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
928
IPv6 Basics