CLI Guide

Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information This command allows you to monitor adjacency state changes, which are useful
when you monitor large networks. Messages are logged in the system’s error
message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l |
level-2] interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the
configuration to generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the
configuration to generation of Level-2 LSPs.
interval seconds Enter the maximum number of seconds between LSP
generations. The range is from 0 to 120 seconds. The
default is 5 seconds.
initial_wait_interv
al seconds
(OPTIONAL) Enter the initial wait time, in seconds, before
running the first LSP generation. The range is from 0 to 120
seconds. The default is 1 second.
Intermediate System to Intermediate System (IS-IS)
993