Concept Guide

PRIORITY-GROUP
PROTOCOL GVRP
QOS POLICY
RSTP
ROUTE-MAP
ROUTER BGP
BGP ADDRESS-FAMILY
ROUTER ISIS
ISIS ADDRESS-FAMILY
ROUTER OSPF
ROUTER OSPFV3
ROUTER RIP
SPANNING TREE
TRACE-LIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
uBoot
Navigating CLI Modes
The Dell EMC Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the
command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit command which moves
you up one command mode level.
NOTE
: Sub-CONFIGURATION modes all have the letters conf in the prompt with more modiers to identify the mode and slot/
port information.
Table 1. Dell EMC Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC
DellEMC>
Access the router through the console or
terminal line.
EXEC Privilege
DellEMC#
• From EXEC mode, enter the enable
command.
• From any other mode, use the end
command.
CONFIGURATION
DellEMC(conf)#
• From EXEC privilege mode, enter the
configure command.
• From every mode except EXEC and
EXEC Privilege, enter the exit
command.
NOTE: Access all of the following
modes from CONFIGURATION
mode.
AS-PATH ACL
DellEMC(config-as-path)# ip as-path access-list
Gigabit Ethernet Interface
DellEMC(conf-if-gi-1/1)#
interface (INTERFACE modes)
10 Gigabit Ethernet Interface
DellEMC(conf-if-te-1/49)#
interface (INTERFACE modes)
40 Gigabit Ethernet Interface interface (INTERFACE modes)
38 Conguration Fundamentals