White Papers

GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned NO Manual administratively down down
GigabitEthernet 1/3 unassigned YES Manual up up
GigabitEthernet 1/4 unassigned YES Manual up up
GigabitEthernet 1/5 unassigned YES Manual up up
GigabitEthernet 1/6 10.10.10.1 YES Manual up up
GigabitEthernet 1/7 unassigned NO Manual administratively down down
GigabitEthernet 1/8 unassigned NO Manual administratively down down
GigabitEthernet 1/9 unassigned NO Manual administratively down down
To view only congured interfaces, use the show interfaces configured command in the EXEC Privilege mode.
To determine which physical interfaces are available, use the show running-config command in EXEC mode. This command displays
all physical interfaces available on the system.
DellEMC#show running
Current Configuration ...
!
interface GigabitEthernet 2/6
no ip address
shutdown
!
interface GigabitEthernet 2/7
no ip address
shutdown
!
interface GigabitEthernet 2/8
no ip address
shutdown
!
interface GigabitEthernet 2/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
3 Verify the conguration.
INTERFACE mode
show config
All the applied congurations are removed and the interface is set to the factory default state.
Interfaces
323