Command Line Reference Guide

sflow enable (Global)
Enable sFlow globally.
S5000
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
sFlow is disabled by default. In addition to this command, sFlow needs to be enable on
individual interfaces where sFlow sampling is desired.
Related
Commands
sflow enable (Interface) – enables sFlow on Interfaces.
sflow enable (Interface)
Enable sFlow on Interfaces.
S5000
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going out of the
interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from
the LAG port.
Related
Commands
sflow enable (Global) – turns sFlow on globally.
1183