Command Line Reference Guide

vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
S5000
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible
command.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must remove the members prior to disabling the stackable VLAN feature.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode.
Stackable VLANs contain members, designated by the M in the Q column of the command
output.
Example
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Te 13/13
M Te 13/0-2
3 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/3
4 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/4
5 Active M Po1(Te 13/14-15)
M Te 13/18
M Te 13/5
FTOS#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas and dashed ranges are
permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of conflicts.
S5000
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
1285