Command Line Reference Guide

PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies the PFC and
ETS settings on Ethernet ports.
show interfaces dcbx detail
Displays the DCBx configuration on an Ethernet interface.
S5000
Syntax
show interfaces type slot/port dcbx detail
Parameters
interfaces type
slot/port
Enter the interfaces keyword followed by the Ethernet interface
type and slot/port or number information. Valid slot numbers are 0-11.
The valid port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To clear DCBx frame counters, use the clear dcbx counters interface stack-
unit/port
command.
The following table describes the show interface dcbx detail command output
shown in the Example below.
Table 1. Output Fields for the
show interface dcbx detail
Command
Field Description
Interface Interface type with chassis slot and port
number.
Port-Role Indicates the configured DCBx port role:
auto-upstream, auto-downstream, config-
source, or manual.
403