Command Line Reference Guide

ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are
not configured, the CAM can hold a maximum of 16 ecmp per route.
S5000
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-paths Specify the maximum number of ECMP for a route. The range is 2 to
64.
path-fallback Use the keyword path-fallback to enable this feature. If you
enable the feature, re-enter this keyword to disable the feature.
Defaults 16
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then reload the
system for the new settings to take effect.
Related
Commands
show ip cam stack-unit – Display content-addressable memory (CAM) entries for an S5000
switch.
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution will begin being monitored on an ECMP
link bundle.
S5000
Syntax
link-bundle-distribution trigger-threshold [percent]
Parameters
percent Indicate the threshold value when traffic distribution will start being
monitored on an ECMP link bundle. The range is 1 to 90%. The default
is 60%.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
436