Command Line Reference Guide

fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
S5000
Syntax
fip-snooping fc-map fc-map-value
To remove the configured FM-MAP value, use the no fip-snooping fc-map command.
Parameters
fc-map-value Enter the FC-MAP value FIP snooping uses. The range is 0EFC00 to
0EFCFF.
Defaults 0x0EFC00
Command Modes
• CONFIGURATION
• VLAN INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
fip-snooping max-sessions-per-enodemac
Configure the maximum number of FIP-snooping sessions supported on the switch for an ENode MAC address.
S5000
Syntax
fip-snooping max-sessions-per-enodemac max-value
To remove the configured number of supported sessions, use the no fip-snooping max
—sessions-per-enodemac command.
Parameters
max-value Enter the maximum number of FIP snooping sessions with an ENode
that are supported on the switch. The range is 1 to 64.
Defaults 32
Command Modes
• CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The maximum number of supported FIP snooping sessions that you configure is displayed in
the running configuration (if it is not the default value) and in show fip-snooping
config output.
If you configure a smaller number of supported sessions than was previously configured, all
current FIP snooping sessions continue and a warning message is displayed. If a greater
442