Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN does not yield results.
Example
FTOS#show ip igmp interface
TenGigabitEthernet 0/0 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/5 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/6 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/7 is up, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 7/9 is up, line protocol is up
Internet address is 10.87.5.250/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP activity: 0 joins, 0 leaves
IGMP querying router is 10.87.5.250 (this system)
IGMP version is 2
show ip igmp ssm-map
Display is a list of groups that are currently in the IGMP group table and contain SSM mapped sources.
S5000
Syntax
show ip igmp ssm-map [group]
Parameters
group (OPTIONAL) Enter the multicast group address in the form A.B.C.D to
display the list of sources to which this group is mapped.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip igmp ssm-map – Uses a statically configured list to translate (*,G) memberships to (S,G)
memberships.
483