Command Line Reference Guide

ip host
Assign a name and IP address to be used by the host-to-IP address mapping table.
S5000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped to the
name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
S5000
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-count
command.
Parameters
count Enter a number for the number of fragments allowed for re-assembly.
The range is 2 to 256.
Defaults No limit is set on number of fragments allowed.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-
assembly low.
574