Command Line Reference Guide

Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10
l2qos 1-10
Allocate space to support IPv6 ACLs. You must enter all of the profiles
and a range. Enter the CAM profile name followed by the amount to
be allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
For the new settings to take effect, you must save the new CAM settings to the startup-config
(write-mem or copy run start), then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-egress
Allocate space for IPv6 egress ACLs.
S5000
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl
1- 4 ipv6acl 0-4
Allocate space to support IPv6 ACLs. You must enter all of the profiles
and a range. Enter the CAM profile name followed by the amount to
be allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
604