Deployment Guide

68 Leaf-Spine Deployment and Best Practices Guide | Version 1.0
A Dell EMC Networking switch factory default settings
All Dell EMC Networking switches in this guide can be reset to factory defaults as follows:
Dell#restore factory-defaults stack-unit unit# clear-all
Proceed with factory settings? Confirm [yes/no]:yes
Factory settings are restored and the switch reloads. After reload, enter A at the [A/C/L/S] prompt as shown
below to exit Bare Metal Provisioning mode.
This device is in Bare Metal Provisioning (BMP) mode.
To continue with the standard manual interactive mode, it is necessary to
abort BMP.
Press A to abort BMP now.
Press C to continue with BMP.
Press L to toggle BMP syslog and console messages.
Press S to display the BMP status.
[A/C/L/S]:A
% Warning: The bmp process will stop ...
Dell>
The switch is now ready for configuration.